К содержанию
CiteXCiteX — научный поиск с источниками
РецензированоEN2020

TECHNOLOGIES FOR PROCESSING WORKING PARTS OF DIES USED IN COLD VOLUME STAMPING

Ergashev Dilshodbek Маmаsidiqоvich (Phd. Andijan Machine-Building Institute, Andijan, Uzbekistan)

The American Journal of Engineering and Technology · 05 · 2020

Аннотация

This paper presents an analysis of the technical requirements for cold stamping, wear of their working zones, factors affecting wear and ways to increase wear resistance. KEYWORDS Cold stamping, bending, tool steels, alloy steels, carbon steels, strength, hardness.

Доказательный фрагмент

«This paper presents an analysis of the technical requirements for cold stamping, wear of their working zones, factors affecting wear and ways to increase wear resistance.»

Образец извлечения

Демо-превью

This paper presents an analysis of the technical requirements for cold stamping, wear of their working zones, factors affecting wear and ways to increase wear resistance. Полный текст публикации CiteX не хранит — доступ к первоисточнику открывается по DOI согласно лицензии издателя и выбранному плану.

doi.org/10.37547/tajet/Volume05Issue12-05
Цитирований
0
Тип
Журнал
Страна
Узбекистан
Ключевые слова
Cold stamping, bending, tool steels, alloy steels, carbon steels, strength, hardness, The installation angle of the picker in relation to the direction of movement, the movement speed of the unit, the diameter of the picker
Открыть DOI
Спросить CiteX об этой работе

Смежные источники