К содержанию
РецензированоEN2022

Study of rib bending at installation of insertion into rib

Mukhammadiyev D. · Akhmedov Kh. · Ergashev I. · Zhamolova L. · Mukhammadiyev T.

Научные статьи · 2022

Аннотация

The existing rib designs are made taking into account their one-time use, which leads to an increase in financial and resource costs and a low accuracy in the assembly and in the strength of the grate. In addition, the practice of using grates in cotton ginning plants has shown that ribs in grate grills are worn out from the touch of the saws due to their warping and errors in the assembly of the grate. The wear of the grate in the working area leads to an increase in the inter grate clearance in the contact area with the saw blade and to a failure of the ginning process. To eliminate the above disadvantages, a new steel grate structure with an insert (a replaceable element) as a curved sheet is proposed; its ends are made in the form of a trapezoid. The grates have a ledge for a rigid and secure attachment to the bar. On the surface of the bar, there are holes for connecting the bar with the grate, made in the form of a quadrangle. However, in the scientific literature on the topic, there is no information on the study of the bending of the grate during the installation of the insert into the grate. Calculation schemes and experimental setups are proposed to establish the value of the grate deflection during the installation of the insert into the grate (cantilever installation and the installation on two supports). The values of the permanent deformation on the grate after installing the insert are: when the form is a rectangle – 0.016 mm, a triangle – 0.05 mm, and when the insert has a circular form – 0.08 mm. Therefore, the rectangular shape of the ends of the insert is a rational one. Using the recommendations for installing the insert in the grate will significantly reduce production costs and increase the level of accuracy during assembly, as well as the strength of the grate.

Доказательный фрагмент

«The existing rib designs are made taking into account their one-time use, which leads to an increase in financial and resource costs and a low accuracy in the assembly and in the strength of the grate.»

Образец извлечения

Демо-превью

The existing rib designs are made taking into account their one-time use, which leads to an increase in financial and resource costs and a low accuracy in the assembly and in the strength of the grate. Полный текст публикации CiteX не хранит — доступ к первоисточнику открывается по DOI согласно лицензии издателя и выбранному плану.

DOI не указан
Цитирований
0
Тип
Журнал
Страна
Узбекистан
Спросить CiteX об этой работе

Смежные источники