К содержанию
РецензированоEN2013

Economical Steel Plate Shear Walls for Low-Seismic Regions

Hassan Moghimi

Научные статьи · 2013

Аннотация

Previous research on steel plate shear walls (SPSWs) and current design codes have focused principally on achieving highly ductile behavior through stringent detailing requirements. As such, the system is generally considered to be economical only in high-seismic regions. However, lower demands in other regions may permit the use of more economical options. This paper describes a proposed concept for SPSWs that meets the intent of capacity design, while greatly improving competitiveness in seismic regions where maximum ductility is not required. A large-scale, 2-story SPSW specimen was tested to evaluate the associated performance. The wall had standard double-angle beam-to-column shear connections and was tested under vertical gravity load concurrent with reversing lateral loads at each floor level. The specimen survived 25 lateral load cycles, 18 of which were in the inelastic range. The test results indicated that excellent performance can be expected in lowseismic regions, despite significantly reduced costs, compared with traditional designs. The shear wall showed stable performance at large lateral deformation ratios with high levels of ductility and energy dissipation capacity.

Доказательный фрагмент

«Previous research on steel plate shear walls (SPSWs) and current design codes have focused principally on achieving highly ductile behavior through stringent detailing requirements.»

Образец извлечения

Демо-превью

Previous research on steel plate shear walls (SPSWs) and current design codes have focused principally on achieving highly ductile behavior through stringent detailing requirements. Полный текст публикации CiteX не хранит — доступ к первоисточнику открывается по DOI согласно лицензии издателя и выбранному плану.

DOI не указан
Цитирований
0
Тип
Журнал
Страна
Узбекистан
Спросить CiteX об этой работе

Смежные источники