К содержанию
РецензированоEN2026

DETERMINATION OF THE EFFICIENCY OF THE SOUTH MIRZACHOL MAIN CHANNEL USING HYDROMETRIC AND CALCULATION METHODS

CALCULATION METHODS · Umidjon Sadiev Abdusamadovich · Jovliyev Uktam Temirovich (Research Institute of Irrigation and Water Problems) · Makhmudova Dilbar Ilhomjon kizi (Research Institute of Irrigation and Water Problems) · Xayridinov Sardor Nutfullo ogli (Research Institute of Irrigation and Water Problems)

Академические исследования в современной науке · 410 · 2026

Аннотация

This article presents an analysis of methods for determining the efficiency coefficient of irrigation networks, identifying wasteful consumption of water resources within them, and provides information on technologies for increasing their effectiveness. Key words: filtration, evaporation, channel efficiency coefficient, hydrometric method, balance method, volumetric method, calculation method. Global climate change in Uzbekistan is leading to the following negative consequences. In particular, an increase in the evaporation coefficient of water as a result of rising temperatures is affecting the reduction and scarcity of water resources in the regions; The number of days without precipitation during the year is increasing due to ecological stress; the risk of repeated droughts is increasing due to reduced soil moisture and productivity indicators are falling; the decrease in the volume of water flowing into the Aral Sea is accelerating the desertification of the river delta and the emergence of new desert areas on the dried-up seabed; dust pollution is increasing over large areas of atmospheric air; changes in anomalous phenomena such as warming and cooling are leading to the efficient use of water resources in agriculture [1]. A significant portion of the water diverted from the canal head is lost due to seepage and evaporation before it reaches the fields. By calculating the Useful Work Coefficient (UWC) of a canal, it is possible to determine the actual volume of water that reaches the field and the proportion of water effectively delivered. 54 ACADEMIC RESEARCH IN MODERN SCIENCE International scientific-online conference To quantify water losses caused by seepage—i.e., infiltration into the soil—the following methods are commonly employed [2,3]: the hydrometric method determines the water loss between two levels through hydrometric measurements along the length of the channel. the balance method determines the water loss in a balance area by determining the volumes of water entering and leaving the balance area at a given time. in the volumetric method, selected intermediate dams are used to block both sides of the channel, fill this gap with a certain volume of water, and determine its loss. computational method. In this method, water loss is determined through certain empirical and theoretical expressions. This method provides approximate results and is mainly used in the design of canals. To determine the UWC (Useful work coefficient) of a channel using the hydrometric method, a certain section of the channel is selected. The locations of the upper and lower levels in the selected section are determined [4,5]. The length of the selected section (section) is determined based on the following formula. 67.4∗𝑃 L = 𝑖 (1) where: L is the length of the selected section (section), km; 𝑃– measurement accuracy of individual water consumption, %; 𝑖 𝑃 – accuracy of finding the loss, %; 𝜎 – water loss per 1 km of canal length (as a percentage of water consumption); n- number of measurements. After the water flow is measured in the upper tank, the water flow in the lower tank is also measured. The time it takes for water to reach the lower tank from the upper tank is determined based on the following formula[6,7]. 𝐿 T= (2) 𝑉 ∗60 ср To measure water consumption, hydrometric posts are installed on the upper and lower floors and water consumption is measured. The water loss between the selected sections is determined by the following formula. S=Q - ∑𝑄 + ∑𝑄 – Q (3) .yuq 𝑢𝑟 𝑡𝑎𝑠ℎ past where, Q and Q are the water flows measured and lower levels, m 3 /s; .yuq past ∑𝑄 - the sum of water consumption of all water intake ditches within the ар site, m 3 /s; ∑𝑄 - the sum of water consumption discharged between the sections, m 𝑡𝑎𝑠ℎ 3 /s. 55 ACADEMIC RESEARCH IN MODERN SCIENCE International scientific-online conference Once the absolute value of water consumption loss in a selected section is determined, the relative losses for each kilometer of length are determined using the following formula [8,9]. 1000∗𝑆 S = l/s at 1 km ( 4 ) l 𝐿 The percentage of water loss per 1 km of measured water consumption is determined by the following formula: 𝑆 𝜎= 𝑙 *100 ( 5 ) 𝑄 𝑢𝑟 here, Q +Q Q = yuq past (6) ur 2 The Useful Work Coefficient (UWC) for a given site is determined using the following formula: 𝑄 −𝑆 UWC = 𝑦𝑢𝑞 (7) 𝑄 𝑦𝑢𝑞 As mentioned above, the water loss due to filtration is determined by the calculation method using certain empirical and theoretical expressions. As a result of numerous field studies, the water loss due to filtration (as a percentage of water consumption) per 1 km of canal length is determined by the following formula [10, 9] . 𝐴 𝜎= (8) 𝑄𝑚 where A is a parameter representing the percentage of water lost over a length of 1 km when the water flow of the canal is 1.0 m 3 /s; Q - canal water consumption, m 3 /s; m- a parameter expressing the change in loss when water consumption differs from 1.0 m 3 /s. Below is the UWC of t

Доказательный фрагмент

«This article presents an analysis of methods for determining the efficiency coefficient of irrigation networks, identifying wasteful consumption of water resources within them, and provides information on technologies…»

Образец извлечения

Демо-превью

This article presents an analysis of methods for determining the efficiency coefficient of irrigation networks, identifying wasteful consumption of water resources within them, and provides information on technologies… Полный текст публикации CiteX не хранит — доступ к первоисточнику открывается по DOI согласно лицензии издателя и выбранному плану.

Цитирований
0
Просмотров
0
Тип
Журнал
Страна
Узбекистан
Ключевые слова
filtration, evaporation, channel efficiency coefficient, balance method, hydrometric method, volumetric method, calculation method.
Открыть DOI
Спросить CiteX об этой работе

Смежные источники